[XexisParticipant]

It took Square a couple of years with a massive dev team to code and release this expansion. Miqo’s smaller dev team isn’t going to unravel all that in a couple of days. Agreeing with Lyfox. Chill and don’t harass the devs; having to stop and explain over and over again why it takes time just distracts them from actually working on the bot.

[XexisParticipant]

Gathering is kind of misbehaving even after the update, at least for me. I’m using a grid I’ve previously run for hours on end with no problems (Ai’s grid for Cobalt Ore). The bot will now only run in administrator mode, which isn’t really a big problem, but there’s now a huge delay in the overlay showing up on the screen. When I run the bot I could have it standing right in front of a node and, although I’m using the same settings that worked before, it’ll spin around for ages, run a little, spin, run in another direction, then get lost in the woods and shut down. On a few tries it’s worked to gather for a few minutes, but then shuts itself down spinning aimlessly even with nodes in clear line of sight. The log gives no errors other than poking creatures in the woods.

I dunno if it’s something not working right with the patch or if mine didn’t auto-update like it was supposed to or I’m doing something daft, but I’ve been restarting it over and over again for the past few hours trying to get it working, and it gives up every time.

[XexisParticipant]

That fixed it, thanks. <3 Plus I was doing the coordinates wrong and using actual X/Y from the game instead of from the Monitor tab, because I’m tired and fail at reading basic instructions. Thanks for humoring me.

[XexisParticipant]

I’m not sure if this is an error or me being daft since I’m just trying out scenarios, but I just did a quick chapter to move back and forth between two sandfishing points in Sagolii desert with a pause to re-up skill food:

goToXYZ(25.7, 37.1, 0)
holdKey(Ctrl+=, 1.5)
holdKey(Ctrl+=, 1.5)
fish(60)
goToXYZ(25.0, 35.9, 0)
holdKey(Ctrl+=, 1.5)
holdKey(Ctrl+=, 1.5)
fish(60)
repeatChapter(3)

When I hit Start, Miqo runs away from the marked coordinates, instead heading for the last active mining grid I had going, with this in the log:

(7:23:20 PM) (SCENARIO) Started:
(7:23:20 PM) 	'New Scenario'
(7:23:20 PM) 	Chapter: 1
(7:23:22 PM) Adventure calls! I have to travel far away. (Grid: 'MIN30-BombAsh', 25.70, 37.10, 0.00)
(7:23:22 PM) Going from 10 to 9 in 5 trips.

I don’t know why it’s referencing the grid from the gathering tab (and those coordinates aren’t even the location of the mining grid–and once it gets there it starts running face-first into the wall); is there any way around that, is it an error, or am I overlooking something obvious?

[Author]

Posts