Issue gathering some nodes

Forum › Forums › Discussion › Issue gathering some nodes

This topic contains 3 replies, has 2 voices, and was last updated by Lyfox Lyfox 7 years, 2 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 27, 2017 at 5:59 pm #5170
    VanGuard
    VanGuard
    Participant
    0

    Has anyone had a issue with the bot running past random nodes to go around the whole loop before gathering from it finally? The nodes change as well so it’s almost random for me.

    August 27, 2017 at 8:20 pm #5174
    Lyfox
    Lyfox
    Participant
    0

    Miqo follows the navigation routes you give her. Take a look at the grid youre using if it has badly optimized or disconnected sections.

    August 27, 2017 at 8:42 pm #5175
    VanGuard
    VanGuard
    Participant
    0

    Yeah I built a loop grid for her and have a point set by each node with a one way loop going around the route and she will use the grid perfectly but she runs right past nodes for some reason.

    • This reply was modified 7 years, 2 months ago by VanGuard VanGuard.
    • This reply was modified 7 years, 2 months ago by VanGuard VanGuard.
    August 29, 2017 at 11:46 am #5179
    Lyfox
    Lyfox
    Participant
    0

    Maybe because of compass. Arbor Call points to the closest node in terms of linear distance. But it may be different in terms of your navigation route. Ive seen it a few times but never bothered tbh. Is this an issue to you? If you want i can take a look at your grid and see if it can be optimized.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.