Dawntrail 7.0 Gathering Grids

[CaffeinatedGremlinParticipant]

Alright! I’ll be dropping Navigation grids in here as I make them. Some of them might be a bit rough, but I’m running them before I post them, so they shouldn’t be too bad. Please let me know if you run into any errors, and I’ll do what I can to correct them.

Requirements:
– Flying unlocked for the relevant zones

Attachments:

You must be logged in to view attached files.

[CaffeinatedGremlinParticipant]

Some BTN grids – both Collectables & regular nodes

Attachments:

You must be logged in to view attached files.

[CaffeinatedGremlinParticipant]

More BTN grids

Attachments:

You must be logged in to view attached files.

[CaffeinatedGremlinParticipant]

Reposting the Ra’kaznar Ore grid since I made sure White Gold Ore was also marked in it.

Attachments:

You must be logged in to view attached files.

[Torr86Participant]

Mind making some for the 90-94 nodes?
Like Snow Cotton? Would be greatly appreciated 😀

[CaffeinatedGremlinParticipant]

Absolutely! That’s on my To-Do list. I’d have them up already but it’s been a crazy week IRL. Lol. I’ll see what I can do to get some of those done and posted today. 🙂

[CaffeinatedGremlinParticipant]

Some Lvl 90-94 BTN grids- plus a BTN96 grid for White Pepper & Sarcenet because someone else requested that in particular a little while back.

Attachments:

You must be logged in to view attached files.

[bubula456Participant]

Thanks, a lot helpful, but for me when i activate it always get stuck in 1 navigation node and it only stay there not moving the other nodes so its break down. its like gather 2 noder reset to 1 becon and stops since there no nodes close and stays like that even tho it haves diferents becons.

[CaffeinatedGremlinParticipant]

I’m sorry to hear that, Bubula456. Could you provide me the Miqobot log so I can try to see where the issue is?

Also, which navigation grid are you having this issue with? I don’t recall setting more than one (1) beacon per grid, but if I know which navigation grid is giving you this problem, I can take a look at it to make sure.

Screenshots of the waypoint it’s getting stuck on would also be helpful, but not as necessary as the Miqobot log and the name of the grid.

• This reply was modified 2 months, 1 week ago by  CaffeinatedGremlin.

[CaffeinatedGremlinParticipant]

I just had another thought, Bubula456. Do you have ‘Use Compass’ checked under the ‘Senses’ section on the ‘Gathering’ tab in Miqobot? That should also help Miqobot register other nodes on the grid, nearby.

I try to make sure the only beacon on my grids is placed right in the center of the area where the relevant nodes spawn. There are typically three (3) clusters of nodes scattered around that area, and each is connected to the beacon in the center of the gathering location, so it can get to all of them- plus, interconnected flight points along the grid at each of the three clusters.

[CaffeinatedGremlinParticipant]

More MIN nav grids. I’m almost done with these!

Attachments:

You must be logged in to view attached files.

[CaffeinatedGremlinParticipant]

More MIN nav grids. This should be the last of the 91-100 (Dawntrail) regular MIN nodes. 😀

Just gotta finish up the BTN nodes now~.

Attachments:

You must be logged in to view attached files.

[ScientiaParticipant]

Thank you so much for these!

If you’re working on BTN nodes, could I request Turali Corn? It’s the only grid I’ve been looking for since launch and there still doesn’t seem to be one yet.

Thank you again for the all grids you’ve uploaded!

[btheleeParticipant]

The gathering grid for White Pepper doesn’t repeat past the first node at each location, it just gets stuck going to the beacon (trip 16) (Going from 16 to 16 in 1 trips.) Idk what causes it to do this but thought i’d raise it to your attention

[Author]

Posts